Mounting the Quick Plate

Mounting the Quick Plate to the Bracket

You may mount two Quick Plates, back to back, on the Bracket 1 HD, Bracket 1 mini, Over Camera Plate, or Position Plate. It is also possible to mount the Quick Plates in a horizontal position on the Bracket 1 HD, Bracket 1 mini, or Position Plate, to more easily see and use the controls on your hard disk recorder.

To mount a single Quick Plate, use the four black screws. Insert the screws through the holes on the back of the bracket and into the threaded holes on the Quick Plate (picture 1).

To mount two Quick Plates, back to back, use the silver screws that are provided (pictures 2, 3 and 4). Insert a screw through the upper left and lower right corner of each Quick plate, then through the corresponding hole in the bracket, and into the threaded hole in the upper right and lower left of the opposite Quick Plate. (The Quick Plate in the second picture has the velcro strap removed to better show the screws)

To mount the Quick Plate in a horizontal position, use the medium size silver screws through the holes and slot on the extreme edges of the bracket into the threaded holes in the Quick Plate (picture 5).

The Quick Plate can also be mounted on any camera set-up that has industry standard mounting pattern threaded holes (including any of the Bracket 1 bracket systems) by inserting the medium size silver screws through the appropriate holes from the front side of the Quick Plate.

Mounting accessories to the Quick Plate

Loosen the velcro strap and slide the wireless receiver or other accessory in until it's against the metal tab. Snug the velcro strap tight while pushing the accessory against the rubber backing strips. Latch the velcro strap. If the strap isn't long enough to securely latch, order the appropriate Longer Velcro Strap.